Super cute! It didn’t fit on my print bed so I had to reduce to 90%. Reducing stands by 90% on the Y axis didn’t work though so I had to glue the stork to the stand. It still looked great on the diaper cake I made for friend’s baby shower.

Printed very nice! I will lower infill next time to shorten print time.

Very nice print! I think I will lower the infill on next one so it prints quicker.

Printed very nice. I made one in black and one in grey to represent the switch to stealth mode.

Model printed very nice.

Printed very nice.

Did not realize I was printing the bigger version but it came out very nice.

Came out very nice.

Love it! I highly recommend this print.

Lovely design. I need to get better at removing supports. 10/10 I recommend this design. 😊

Printed in rainbow and put on my deak for paper clips and other small things. I am always amazed at how light weight PLA is. 10/10 I recommend this design.

Very nice print. only print fail I had was from not cleaning plate and using glue. 10/10 I recommend this design.

Very nice. I think it would make a nice kraken-like pen holder for my desk. 10/10 I recommend this design.

Super cute. Especially after I painted the eyes on. 10/10 I recommend this design. Please make it a keychain and also a monitor buddy! 😁

8” version is perfect fit for both my Kobalt and US General mini tool boxes. 10/10 I recommend this design.

Very nice, fits well in both my Kobalt and US General mini tool boxes. 10/10 I recommend this design.

Very cute.

Fabulous! Printed it in copper silk PLA. Will make great addition to my Halloween desk decor!

Love it. Some minor roughness with underneath portion of tray, but not visible from top/front. Great additions if you don’t need to close the lid. Please look into creating set with magnets so lid can close.

Very nice design. Printed very well on my P1S. It took a few hours but was worth the wait. Spins very nicely! 10/10 I recommend this design.