thomas_schoendorf

NagyBig

Make someone happy, give a seal of approval.Printed with no supports.1.6 layer height

Seal of approval

tiere

Miguel M.

LED strip clip.Simple and works very well. Screws on one side only, so very compact. fits 10mm strips.Do not attempt to print on its side, screw will split the layers and crack the print…..I printed 24 of these all at once with no problems. Even that small tip had no problem sticking to the bed with no brim.UpdateSee my remix of this strip, designed for mounting 2 parallel strips.<a target="_blank" href="https://makerworld.com/en/models/492531" rel="nofollow noopener">https://makerworld.com/en/models/492531</a>And If you have a minute, check out my other models!&nbsp;&nbsp;&nbsp;&nbsp;

LED Strip Clip

skadis

dugy58

I made this is Tinkercad,its has threads that match the z rod. you can lube the z rod while the rod is turning if your careful. Also put a small patch used for gun cleaning on this and press into the z rod and it will also clean it. My favorite tool.

Z Rod Luber. With threads.

printer addons

3Deste

This is my version of soldring wire holder.So simple as funcional.I use it with 250gr spool.Printed with PLA but every material is ok.Support not needed, layer high 0.2mm or higher, minimum 3 wall loops, infill 15%.If you like this model, please, leave a like and publish a picture of your print :)Alex&nbsp;

Soldering wire holder

werkzeug

phyXoo

50% scale modelSmoothened top surfaces

Blastoise - Pokemon

pokemon

Ming Yao

This hook is designed as an upper and lower hook. The upper hook is larger and the lower hook is smaller. It is suitable for hanging coats and keychains that are often used when going out. You can hang them at the desired height or position as you like.

tiere

skadis

printer addons

werkzeug

pokemon

test