watch stand that prints in two peices, glue is optional but i would suggest it if you have a heavy watch. made in fusion 360.

Small portable Phone holder, check it out? #Sharing Makes #Newmodel

pencil/pen case I made, can hold about 10 #Sharing Makes #Newmodel

Contains 4 different container sizes, small (52hx50w) Tall (90hx50w) Wide (52hx100w) and Large (104hx100w) The TALL and SMALL containers can use the same top, the other 2 have ones specifially for them. As of now I have ONLY made the small one, I will make updates when I've made the rest. use supports for the design on the outside of the jar lids, for the WIDE jar you might also need support for the threads. the filaments I used are black and white ender fast pla and blue anycubic pla. I dont know what the red was it was just some old stuff I had lying around. #Newmodel #Sharingmakes

made a print profile for my model finally, just had to figure out how#Sharing Makes

first little thing i made using fusion 360! trying to learn how to 3d model for myself just as a side thing. #Sharing Makes

Small jar/container thats 52mm tall and has a diameter of 50mm. you can print it with or without the colored ring, to install the ring just twist it on between the threads and then glue it down. this is the first model ive made using fusion 360!

first time i used blender to make something and it took me over 4 hours case for graphgear 1000

second larger model ive put together

i made this whole model just in orca slicer because I wanted to use some small magnets ive had for years.