Maoirae

This is front cover for print head for A1 and A1mini, that I created to make printer a little different. Its made in geared, steampunk design.&nbsp;Frame is the same for all my designs so you print just one and change faceplates as you like.&nbsp;To install put gear pin in gear and then click it in faceplate as shown on pisture.<img src="https://makerworld.bblmw.com/makerworld/draft/498195/2024-02-02_5c31e7a49df74.jpg">&nbsp;Then just press faceplate into frame at all four corners.&nbsp;Than remove original faceplate and extruder visualizer from your printer and just clip frame to print head instead of original faceplate and than instal gear as extruder visualizer.&nbsp;Check yout my other designs :)

A1 & A1 mini Hotend Face Plate Cover Gears

A1 Mini

FallenAngel

Mug to hold typical beer cans ( The slot is ~70mm in diameter). Mug's Height is ~150mm &nbsp;Note: requires Support at few areas.

Mug - Dragon Version 

charlotte

DINO2211

This is a mechanical calendar.All you need is glue to put it together !The step pictures for assembly are in documentation

Mechanical Calendar

Desk

LoboCNC

This wide, comfortable bucket handle grip snaps in place and won't rotate in your hand like the cheesy grips that come on standard 5 gallon buckets. For 5 gallon buckets with a 0.150" dia. handle wire.Prints easily on end, but you might want to add a brim for good measure.<h3>Print Settings</h3>Printer:UDIORafts: <div>No</div>Supports:NoResolution: <div>0.2mm</div>Infill:25%Filament: Inland PLA Notes: <div>Use at least 3 perimeter lines when printing. 4 is better.</div>Category: Outdoor & Garden

Bucket Handle/Grip

Tools

Nomad07

Gridfinity Bambu Misc. Storage tray for cutters and wipers for the Bambu X1C and P1P.

Gridfinity Bambu Misc Storage

Gridfinity

Marc Elbichon

Inspired from <a target="_blank" href="https://www.youtube.com/watch?v=QHkh-4iYq1U" rel="nofollow noopener">Kreg True-FLEX™ Featherboards</a>&nbsp;There are two versions, « TF_Featherboard_Easy_to_print.stl » is easier to print but need a little more material (~15%).« TF_Featherboard.stl » need less material, but is a little harder to print (warping, stringing,...) and longer. Use it if your printer is well adjusted. Use 100% infill for this one. Support are optionals, but helps for the hoverang sections.&nbsp;You can print many featherboard and stack them, just use two « TF_Spacer.stl » between each. You can stack 2, 3, 4... or more featherboards, usefull for resawing big parts on a bandsaw for example.&nbsp;For T-Track/T-Slot you can use a 1/4-20 hex bolt, the lenght depend of how many featherboard you stack.For miter gauge track, I provide an 'adapter' that works with 1/4-20 hex bolts tooAlso, I designed a knob for a 1/4-20 nut.&nbsp;Print with tought material (abs, petg,...), remember it is a safety part !

A1 Mini

car

charlotte

Desk

Tools

Gridfinity

Woodwirking