very good configuration with angled keys to register one piece to the next. I prefer the reversed last piece. it would be nice if both versions were available in the same print.

fun and neigh-indestructible.

easy print but you cannot put in a pound of strawberries and get it to spin as easily as a pint of blueberries. your milage may vary.

this is really nifty

the funnel has failed to print in two different runs

This looks so good in person, the normal print is about 4 inches tall.

Works well

Fun little print

Great print but I am unable to source the command strips to wall mount. Where are people getting it from and what?

Works well. can handle anything I have.

worked well, wish it was a little wider. I printed this because I found most of my existing filaments were too wide to go into an AMS. Turns out you can replace the spool holder with a dowel, but Amazon basic PLA is almost exactly the same width as the feeding spool. I made the other one as well. I am going to get mileage out of both. thanks for making them available.