tdhtdh

EPIQ3D

Make All your herbs easy in the kitchen.This planter ensures that your herbs stay fresh and hydrated.&nbsp;<figure class="image image_resized" style="width:84.24%;"><img src="https://makerworld.bblmw.com/makerworld/draft/836596/2024-04-09_ede14bf23669e.png"></figure>&nbsp;<h3>HOW IT WORKS</h3>The self watering planter is designed to slowly absorb water from the reservoir (This needs to be filled up occasionally).Its a one piece print (uni body).&nbsp;<figure class="image image_resized" style="width:84%;"><img src="https://makerworld.bblmw.com/makerworld/draft/836596/2024-04-09_2bdf03c8c5f73.png"></figure>&nbsp;The water inlet, is alongside the upper part, and is guided down to the reservoir. This also acts like a overflow, so you dont overfill the reservoir. (Stop filling in water, when is reaches the edge, or when it pours over - you decide)&nbsp;It is recommended to use a wicking material at the center (between the soil and the water).This helps to absorb water into the soil slowly. You can place a couple of cotton balls / cotton wool in the bottom of the pot.I recommend filling wicking material so it is above the reservoir edge, then fill with soil, and your herb of choice.&nbsp;&nbsp;Basic print settings:<ul><li>Infill : 10%</li><li>Walls: 3</li><li>Top/bottom shell layers: 3</li><li>No support needed</li></ul>Dimensions: hight 70mm, Crossection: 74mm (at the widest point)

Self watering herb/flower pot

scratchmade

EzzySziggy

A keychain of a cute stylized bulldog , there is also a version included without the ring just for decoration

Stylized Bulldog Keychain

keychains

fwlogue

I created a stand for an arc Lithophane. I used Luban3d Software to generate the Lithophane. The picture that I started with is 966 PX x 1134 PX. &nbsp;My settings in Luban are:&nbsp;<img src="https://makerworld.bblmw.com/makerworld/draft/380554/2024-01-09_733fb2a54bea.png">The light that I used is this one from Amazon https://www.amazon.com/dp/B07Q2HT3ML?ref=ppx_yo2ov_dt_b_product_details&th=1.

Lithophane Stand

lithos 

Clayton Merkle

A very sturdy paper towel holder for mounting under a desk/workbench/cabinet. I tried printing other various paper towel holders from Printables before and they all seemed flimsy or didn't fit together right, so I decided to design my own. The paper towel roll is held in place by threaded knobs on either end. The brackets are designed to mount to the bottom of the desk/workbench/cabinet using command strips or double sided tape, since I did not want to drill holes in my new desk. I used 2x command strips per side, and it feels very sturdy.You must print one of each bracket (left and right) and two knobs. I used coextruded silk PLA, but any rigid filament should work.&nbsp;

scratchmade

keychains

lithos

Things!