stuarts

TS.Makers

Top your christmas tree with style with this Super Mario Xmas tree topper. The model comes with a slot to slot in a Xmas tree LED to light it up though may not be effective depending on your choice of filament. Please read the following considerations when printing with my profile. &nbsp;The tree topper coil prints like a solid blob with my pre loaded support settings. The coil is actually flexible and supports can be released by gently bending the coil and pulling off the support with pliers. Glue is highly recommended when printing the star. The eyes are pressure fit and do not require glue as long as your printer is well calibrated. Needle nose pliers are the only tool needed for this model. Assemble by threading the coil into the bottom of the star. &nbsp;I dont own an Xmas tree but I tested the coil on an Elf tree. If the coil is too short add a little bit of heat via blow dryer or hot watter while attacked to the star and streach out the coil. If you find this is insufficient feel free to PM me a length of coil you need and I'll see what I can do.

Super Mario Power Star Christmas Tree Topper

fun ideas

calebtimoteo

Any feedback would be greatly appreciated.Could be use as a planter, pen holder, etc&nbsp;Nozzle:0.4-0.8mmLayer:0.24-0.4 (Recommended)&nbsp;No Supports needed&nbsp;Scale it as you like :)

Death Star - Star Wars Pot Plant

shawn

eatrix

Planter “Mother and Child”&nbsp;This might be a perfect gift for your mother (or significant other) to show them, that you appreciate their love.&nbsp;Bigger head size is about 100 mm (3.94 inch) diameter, smaller ~ 80 mm (3.15 inch). It should be fine to scale bigger.&nbsp;For this model I chose Bambulab strength profile, because external wall speed is slower and it model looks better on some filaments.It adds a little bit extra time (about 40min), but I think it&#39;s worth it.&nbsp;This model needs some support on arms, model is presliced with tree supports.I like to print these planters with fuzzy skin turned on (contour, fuzzy skin distance - 0.3, fuzzy skin thickness - 0.1).It can be printed smooth also, just be sure to check if seam is placed at Back/Rear.&nbsp;When planting cactus or succulents at the bottom I add a little bit of pebbles for drainage and then potting soil.And don&#39;t forget to water it according to your plant needs :)&nbsp;You can find other similar People planters at my profile:&nbsp;<img class="image_resized" style="width: 22.02%" src="https://makerworld.bblmw.com/makerworld/model/DSM00000000453527/design/2024-05-15_4a3cf01211066.jpg"><img class="image_resized" style="width: 22.09%" src="https://makerworld.bblmw.com/makerworld/model/DSM00000000453527/design/2024-05-15_40783516be3fa.jpg"><img class="image_resized" style="width: 22.03%" src="https://makerworld.bblmw.com/makerworld/model/DSM00000000453527/design/2024-05-15_8f7aeaa76f35c.jpg"><img class="image_resized" style="width: 22.08%" src="https://makerworld.bblmw.com/makerworld/model/DSM00000000453527/design/2024-05-15_34f1c79972c7e.jpg">

Planter "Mother and Child"

jules

AVGCZ2

Johnny 5 will need to be printed with all the listed parts with the following settings below.

fun ideas

shawn

jules

mike