worked great I made a little spacer for the 'shorter' glue sticks I use https://makerworld.com/en/models/1929520-glue-stick-spacer-for-epshapes-hot-glue-gun-stand#profileId-2071194

printed great

had a couple teeth fail but I ended up using up some old ABS that I wasn’t at all tuned for

this printed awesome

worked great

scaling everything to 200% causes some issues, but it turned out really well for such little filament

printed great

worked great, thanks!

prints great, the dividers were a little snug, but I’m printing with cheap pla and the generic profile so that’s probably on me

profile worked great, used polyterra marble pla filament

printed well, fits great

printed a ton of these for my toolbox te organization project, they work great

Prints and fits great, but you should probably use PETG or something a bit slicker. With PLA the poops can stick to the ramp. I saw on another model the suggestion to use a bit of aluminum HVAC tape to make things slide, which is probably the move if you've already printed this.

printed perfectly, the latches are pretty stiff but I'm sure they'll wear in