Quick, clean print!

The edge where the two halves join could use additional support. I could watch this section fleet while my printer was working on this edge in PETG. This edge had visible issues after printing which made assembly difficult. I added a small support (see picture) to stabilize the thing edge of the print. night and day difference with this addition. When assmbling the PCB into the Hydra base, one of the chips is sitting on top of the bottom edge of AMS motor assembly for slot #3. I left the board mounting screws a little loose as to not flex the board much. Overall a great model. Now I need to find new desiccant holders. The ones I used with the first gen Hydra do not fit.

Works Great!

Minir issue with the support distance making the track pieces harder to mate. Most likely my settings.

Worked great!

Looks great.

Printed great!

worked well!

Turned out great!

Printed 3 copies with Bambu Handy. Pulled them off the plate and broke the first one trying to loosen the pin. the other two cooled enough and work just fine!

Printed great

Printed well

Worked well!

worked well! printed in PCTG!

Fit tolerance for the wall mount insert piece are too tight. printed on both textured and smooth beds.

“Tight fit” case is a little wiggly. printed with Bambu PLA from Handy. slot for camera button could have used a tree support.

printed well. supports were a litttle difficult to remove cleanly on the bottom of the handle.

works with PETG

worked well!

Printed well!