Worked great!

Printed with a .2mm nozzle with a .06mm layer height. Came out great, and will be a fun gift.

I chose to reprint after modifying the thickness. My X1C wasn't doing a great job with the 2 sided model at the original thickness. Came out great after doubling it, and makes it a bit sturdier.

great print! I like the care that was put into the threads. it’s just enough that each platform can be aligned evenly with its neighbor. one note: I had to turn the auxiliary cooling fan down (actually turned it off, and haven’t tested lower speeds) because the base plate & the platforms were being cooled too quickly while next to the fan, which was causing ugly print surfaces.

came out great! used a silk filament and it looks very nice.

I stuck this to an adhesive magnet sheet so I could display it on my refrigerator

printed this at max build volume and it came out great