silverfuel21

kernald

<p>Support for plants around a circular base. Fully parametric (see the attached scad file), to print any size. Print upside down, no support needed whatsoever.</p><p>Scad file parameters:</p><figure class="table"><table><thead><tr><th>Parameter</th><th>Description</th><th>Default value</th><th>Unit</th></tr></thead><tbody><tr><th>inner_diameter</th><td>Diameter between the feet - if your plant has some sort of circular base you want to put this support around of, this is the value you're after. This is also what defines the main diameter.</td><td>56</td><td>mm</td></tr><tr><th>hole_diameter</th><td>Diameter of the hole for the plant. Be mindful that depending on the angles below, the opening will most likely be smaller than that.</td><td>5</td><td>mm</td></tr><tr><th>ring_width</th><td>Width of the outer ring.</td><td>11</td><td>mm</td></tr><tr><th>supports</th><td>Number of supports. Less supports will mean a larger opening to the centre hole, as the angle of the opening is the angle between two supports.</td><td>5</td><td>n/a</td></tr><tr><th>support_angle</th><td>Angle each support occupies. Larger angle means larger supports.</td><td>15</td><td>Degrees</td></tr><tr><th>support_height</th><td>Height of the supports</td><td>30</td><td>mm</td></tr></tbody></table></figure>

Fully parametric plant support 

plants

Chris1974

<p>-Edit-</p><p>I made this special edition christmas hat for the storage box!</p><p>You can find it here: <a target="_blank" href="https://makerworld.com/en/models/70706" rel="nofollow noopener">https://makerworld.com/en/models/70706</a></p><p>-Edit-</p><p>&nbsp;</p><p>I made this storage bin shaped like a LEGO head.</p><p>Included 2 print profiles.</p><p>1: normal size (D=10.2cm, H=11.6cm)</p><p>2: XL size (D=20.4cm, H=23.2cm)</p><p>&nbsp;</p><p>Enjoy and post your makes!!!</p>

plants

to make

Natalie