scribdog

3D Print Stuff

Intended for mixing non-food items:<ul><li>Paint</li><li>2 part Epoxy</li><li>2 part silicone</li></ul>&nbsp;

Small Mixer Attachment for Drill

hobby stuff

Ocular Dynamic

Found n6sxb updated version of the soldering helping hands thats adjustable using a rubber band to hold the wires in place for soldering more secure than the soldering fingers. Threw up this profile to help others!&nbsp;Print two copies each of the rotating and static jaws and one base.&nbsp;Post Printing Instruction:I wrapped some 400 grit wet/dry sandpaper around an exacto knife handle to sand the inside diameter of the pivot on the static jaw parts. It didn't take much to make this joint pivot nice and smooth. You don't have to do this. If they are forced together and worked loose, that will work ok too (as long as you don't break them).I sanded the bottoms (the part that fits into the base) and the sides of the static jaws so that I had a good smooth, but tight fit. Be sure to get the bottoms nice and flat so that they sit flush in the pockets. I glued mine using super glue. They aren't coming apart. Wrap rubber band around em.&nbsp;You can also attach small feet to the bottom to help it grip the table top.&nbsp;

Soldering Helping Hands

cool stuff

M of WI

Propeller 6" x 4.5" 4mm ID&nbsp;Prints fast and is easy to separate from the support.

Propeller 6" x 4.5" 4mm ID

RC Plane

Westonpotter20

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmFilaments Used:     PLA Sunlu Black Transmission Distance: 5     PLA Sunlu red Transmission Distance: 5     PLA Generic Yellow Transmission Distance: 5     PLA Sunlu White Transmission Distance: 5Swap Instructions:     Start with Black     At layer #6 (0.56mm) swap to red     At layer #11 (0.96mm) swap to Yellow     At layer #15 (1.28mm) swap to White for the rest.

fairy hueforge

Wall Art

Calzune

Mouse Boxing (Cat)&nbsp;Check out my other Mouse theme designs here  →  <a target="_blank" href="https://makerworld.com/en/u/4121678592/collections/508368" rel="nofollow noopener">Mouse Collection</a>&nbsp;If you put regular painterstape behind on the print it will stick very good to the wall.<img src="https://makerworld.bblmw.com/makerworld/draft/695367/2024-03-13_aa67bcd0c9f4b8.jpg">

hobby stuff

cool stuff

RC Plane

Wall Art

Mouse Wall Art