Printed on an H2D using Bambu Lab PLA Matte, in fact the same filament used by the designer :-). Really like the simply yet elegant design that really fits exactly as intended. I did take the liberty of reducing the magnet holes (using Solidworks) to accommodate my 8mm round magnets since I didn't have any 10mm ones in my stock. Thanks for making this design available!

Printed on an H2D using Bambu Lab PLA Basic. Super quick and clean print. Below find some quick examples of the improvement gained with the use of this guide. I've got another much longer print underway as I write this and I can say that the improvement there is clearly obvious even in mid-print :-). Thanks for this!!!

Printed on an H2D using Bambu Lab PLA Basic (note that I did choose to switch to Silent mode after about 1/3 of the print was completed, probably wasn't necessary but I tend to do stuff like that when model features get thin :-). For me, my Pigma Micron and Winson & Newton pens fit nice and snug using the 10.5mm adapter. Interestingly, I could use either adapter with the Copic. To use the 10.0mm adapter, I feed the pen in from the cup side as opposed to in from the adapter side.

Printed on an H2D using Bambu Lab PETG Translucent Clear and ASA. You sure know how to take advantage of the full build height of the printer :-). Quite happy with the result ... let's see how quickly it fills up.

Printed on H2D using Bambu Lab ASA and TPU 90A. Excellent result and my first time printing with TPU. Awaiting arrival of filter packs before installing it.

Printed on H2D using Bambu Lab ASA. Excellent result, fits well in the AMS HT. After filling mostly with my funnel from the AMS 2 Pro kit, I was able to hand pack quite a number of desiccant balls in, making sure to get them down into all the corners of the pod :-). Thanks for the design.

Greatly satisfied by these prints. PETG Translucent Purple! Removing supports from the spools took little effort and having to insert/remove the sliding lids a few times was needed to assure that they would insert properly when filled. That said, it was not really an issue. Plan to print some more spools using ASA for use with higher temp filaments.