Printed with CookieCad Dark Magic PLA.

I made this extra large to be a trash bin. I used Polymaker Matte Muted White PLA for the bin and lid and Eryone Tri-Color Silk PLA for the liner.

Used Bambu Matte Dark Green and Overture Matte Tan PLA.

I used the trash can lid and made it much bigger than it was. I had to change the infill to adaptive cubic because on gyroid it was almost 14 hours to print the lid. Adaptive cubic got it down to 5 1/2 hours. I can post print profiles if anyone wants them. It turned out great in x-large size.

This was a really fun project to print. I used a roll of rainbow filament and I was able to get almost every color. These will come in very handy on my nightstand. I printed eight of them and still had a lot of room left over in the holder. So I shrunk the height of that down about an inch.

This profile turned out great. But, I had a really hard time with the one I tried to print on the A1 Mini. I could not get it to stick together. I ended up tossing that one and printed two on my H2D printer instead.

I made two. One for big eggs and one for small eggs. I have 9 hens so this was a fantastic project. Thank you!!

I made mine as big as I could get it while only needing to use one roll of filament. I could have made it even bigger on the H2D. Looks great in my bedroom. Hubby actually likes it too!!

I had to change the settings quite a bit to make mine clear. It took many attempts. But, this one isn’t bad. Looks better in person. Really enjoyed this project. It was fun experimenting.

I made mine smaller and changed patterns to concentric. Used CookieCad Pale Pink PLA.

I made mine smaller and changed patterns to concentric.

I made mine smaller and changed patterns to concentric. Used CookieCad Dark Magic PLA.

I made mine smaller. I used CookieCad Dark Magic PLA.