printed out nice. I cannot find my led strip to test the illumination but it looks lovely

I use this print to help me design my products. I use them in two ways: 1. To sometimes measure how thick a certain thing is. It's not always convenient to do that with my vernier calipers. 2. After I have my first version printed and the tolerances are not right, I know from these tools how much I need to reduce the design by. This way I get almost perfect products that fit my requirements. I have printed a smaller version of this. They help me fit these in even smaller surfaces but by reducing their size I also squished the numbers that are printed on the pieces in the current print that you see in the photos. I colored the raised size legend. I realized that the 0.6 mm relief is not the same as that of all the other sizes.

perfect fit.

The fit and finish is excellent

I am missing one set of caps. This print is what I was looking for

Fits a passport snugly. It is a bit too snug, but that is a good thing; else a passport might fall off when opening the case.

Very lovely design. The batteries fit perfectly and snuggly.

Prints like it should. Two caveats. 1. After being printed, the card removal system needs a hard tug to make it operational 2. Be careful when removing cards. They can easily fly off if not careful.

printed the normal and large sizes. Work out great.

I had a spool roll-over that failed. So the print paused for a few minutes while I fixed that. Still I saw many layers not looking good. See photos. Also there were four spots on the top layer of the base that showed some not-so-good results. Hence only 4 stars. Otherwise all good.

Printed really well. Good toy for a child

Printed without the middle one (with hygrometer, because I was not sure if my hygrometer will fit). Sourced the side ones form another model with a very same design.

Perfect fit. I have used two of the double prints. Stuck using a good quality double sided tape.

Useful tool. Somehow the color was no longer in the device when I had loaded it (must have been something I did), so I painted it again in Bambu Studio. Useful, quick print.

Printed three of these. They look lovely. Printed them in white and put them on a white wall, so they blend in seemlessly.

A great design showing possibilities that 3D printing offers that traditional manufacturing will have issues reproducing easily. Works nicely, though you might almost always need two hands to push towels up in the contraption. n the print side, the only challenge is to remove the support created for the ball in this print (see my photo)

Work as expected. My Viltrox lens case is too big for this but all other lenses do fit.

very good design. it printed out nice. I need to dry my filament a tad bit I fear, else all good

There print is good. there are three interlocking pieces. the lower two fit perfectly. the top one has too much tolerance. So I need to superglue that connection. If the tolerance is adjusted again the print will be perfect

came out nice. my first print. excited