My printer wasn’t homing, and needed to print something quickly, before I sped off to work. Always need these things around the house, but having only bright orange filament, it don’t look as clean as the image, but this is 100% just the filament. The actual design, functionality and look is amazing! Will definitely be printing a stack more of these after changing the filament! Thank you, and well done on a great timeless design.

Never knew I needed another reloading block, as I have several “universal” blocks that works 100%, but this is a nice addition and a very nice fit. The cases fit much deeper than the other 4 or 5 universals I have and this makes it 100 times less likely to be falling over.

Making every day tasks just a little bit less worrisome. I used to pull my laptop everytime I stood up; and now I can kind of lock the cable down. Amazing design and print. Now for the 3 port print.

Works’ a charm! Not 100% sealed on our coffee beans bag, but still great print.

Decided to print it in as close to Glock Orange as possible, loving it. Haven’t range tested it, yet, but dry firing is sure proving its value. I would’ve loved if you could run the magwell with the backstrap, as I run mine on the medium backstrap, but had to remove it, which will most likely mean it’ll only be a short time mod to run before I return to running my setup without. Nonetheleee; great print and design.

It’s hard to get the batteries out, once they’re in there. I drill a hole in the back, and that sorted that out. Otherwise, great print and very nice to use.

Wife started a career in real estate, so this worked a charm as making some house cookies for her colleagues.

Printed it as I’ve never really been sold on the actual design of a front grip, and actually enjoyed the use of this. It took some motivation to get it into the M-Lok slots, but once there; it’s been very sturdy. Never tested with live-fire, but works for basic training, so far.

Not sure if it was my setup or something I did wrong - still a noob, but it was off balance. At slower RPM’s the wobble was very noticeable, but at faster speeds it worked well.

Absolutely love this! I printed this for the range bag, as the ear pro has 2x AAA’s and now it’s keeps in a nice holder, instead of the normal small ziplock. Will look to add a seal maybe to make it a bit more airtight, but not necessary for just the range bag.

Works great for the designated reel. I have a fly-reel that it didn’t work on, but works as described on prescribed reels, printed well too.

I like it. I printed it in PLA, cause I had extra. I don’t have a use for them as I only have a few mags, and they all stay in their designated bags, but this is definitely something worth having if you have extras.

I’m still quite new, so it’s most likely not adjusting the setting correctly or something, but on the one edge, where it loops it was very rough. Very happy, could’ve been better, but I would put that more towards the user than the design. Thank you, wife’s happy.

Is there a .22LR “cap” for this capsule? I see there is a bottom, but not the lid. I’d hate to be the guy rocking up with a .44 Mag lid and then opening to a .22LR.

Print was good, but it got to 99% and then bailed over. New to this, so not sure if it’s something I did or the support. Will run it again and make sure it prints slower, the higher it gets.

Works fantastic! Used it on the range the whole day, printed in PLA and handled the abuse of running around on the outside range.

loving it!