I designed this Air Valve Support ring and plate to work perfectly with my new 3D filament vacuum bags. The support fits snugly under the air valve, preventing it from collapsing against the opposite surface. The simple, symmetric vent design is not only effective but also super easy to print, using very little filament. If you like minimal designs that just work, give this one a try! :)

Hey everyone! I’ve designed a Hex conversion kit for the Tamiya DT-02/DT-03 buggies to allow the use of modern hex wheels, inspired by newer buggy setups. The kit works with stock screws and 5x11x4mm bearings and requires only Traxxas front axles and hex hubs. It’s a simple and cost-effective upgrade to give your Tamiya a more versatile wheel setup. I’ve tested it with PLA, but recommend PETG, ASA, or ABS for better durability. I hope this design makes your RC experience even more enjoyable!

Hello Everyone, This is my version of the Oral-B iO7 charging dock/stand, one of my early 3D designs. As I'm new to 3D printing, I hope you like it! If you have any suggestions or feedback, feel free to reach out. I’m always open to constructive criticism and positive discussions.