riouk83000

Clucky

This is a rotating display table that can also be used as a table to paint 3d printed models. This model prints without the need for any supports or bearings. This model was made in Fusion 360 by myself. The square version of this model can be downloaded here: <a target="_blank" href="https://makerworld.com/en/models/102911#profileId-109589" rel="nofollow noopener">https://makerworld.com/en/models/102911#profileId-109589</a>&nbsp;

Rotating Display Table

a imprimer

THE NOG

For those of us that leave a Christmas tree up year round (we're not lazy, just festive…) here's a cute little pumpkin for it.&nbsp;PrintingI advise enabling adaptive layer height to make it pretty and supports to make the stem print successfully.&nbsp;MaterialsI used PETG to get good layer adhesion to better ensure the stem and loop don't break, but PLA should work too. Either use an AMS or make sure you do a filament switch when it gets to the stem to make it another color!&nbsp;You'll either want to use a paperclip or dedicated ornament hangers to hang these on your halloween tree

Pumpkin Ornament

haloween

Super Mario - Pot à crayons ou à plante Tuyau(Super Mario - Pencil or plant pot Pipe)

pot a crayon tonneau (pencilbox barrel )

lithophanie couleur goldorack et sa boite (goldorack color lithophane and its box)

cadre squelette 3d ( 3d skeleton frame )