the issue I encountered is because when doing the top layer it detached from the base. my printer did not push into the model. the model was hanging from the nozzle and got pushed in at an angle. this is a great model and I probably need to clean my plate! so it printed so perfectly, and then at the end for some reason the printer pushed the nozzle into it and burnt it. I’ve never seen this before. I printed from the app on my P1S. I’m going to slice it from Bambu studio to see what the pathing looks like. but otherwise really great! (note I don’t think this is the fault of the model) edit: I sliced it in studio and the paths look fine. same settings as in the profile. let’s just call this a ghost in the machine!