reneeceldesigns

cyanidesugar

A beautiful hueforge print of a tiger in black and white. An AMS or MMU is not required, however will make the filament swapping a lot easier! &nbsp;Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm&nbsp;Filaments Used: - PLA Siddament Black Transmission Distance: 0.2 - PLA+ Sunlu Grey Transmission Distance: 1.4 - PLA Overture Light Grey Transmission Distance: 1.6 - PLA META Sunlu White Transmission Distance: 9.6&nbsp;&nbsp;Swap Instructions: - Start with Black - At layer #11 (1mm) swap to Grey - At layer #15 (1.32mm) swap to Light Grey - At layer #18 (1.56mm) swap to White for the rest.

White Tiger - Hueforge Print

Hueforge 

capsel22

Quick print of a PTFE clip which goes on the cable chain. Prevents the tube hitting the top glass or ams etc.&nbsp;Printer 0.2 layer heigh with 3 walls. Suggest printing it with PETG at minimum.&nbsp;It's designed to be tight fit. I found other designs to have either the PTFE cut out too large and the tube would come out or the lips holding the cable chain to be too small, and it clips off.&nbsp;To fit it, insert the top first onto the cable chain.