raush

Pot extender (root belt)

Spool Winder split Handle

taylormadearmy

38g Origami shashibo cube zero assembly needed

0.2mm layer, 2 walls, 15% infill

the middle piece is a little tight but it’s not a big issue, it just gives the whole piece a lil gap. not bad, though. very good design

NUKDDD

Spiky Serenity Sphere

1 spiky serenity sphere

it’s huge and I did not understand magnet were supposed to be underwater. is that safe? my tank is too thick, too, so it just doesn’t work. The model itself and the print turned out perfect, though 😅

novYTerra🌿

Aqua Mosswall

180x180mm - 0.2mm layer, 3 walls, 15% infill

the inner pots and the caps are a little tight, once I place them, it’s hard to take them out. nice project, anyway

Planmarks

Modular Hexa Self-Watering Plant Seeding Station 

0.16mm layer, 2 walls, 10% infill

Earn this badge when rate or comment more than 200 different models

Stellar Reviewer

Earn this badge when print successful more than 100 different models and 500 hours

Pioneer Maker

Earn this badge when visit MakerWorld more than 20 days in last 30days UTC time