Tired of my power strip sliding around under my desk, so I designed a clip-on holder for the IKEA Linnmon table. It mounts the power strip under the desk, keeps cables tidy, and doesn’t require screws. Printed in two pieces, no supports needed. Works great for keeping the desk setup clean! Curious to see how others organize their cables 👀

This is a simple, modern fume extractor using a 120mm PC fan and powered via USB-C. It features a replaceable carbon filter, 3D printed housing, and a built-in power switch. Designed for makers and electronics hobbyists, it’s a great weekend project to keep your workspace clean and safe from soldering fumes. Easy to assemble, quiet, and bench-friendly!

Just uploaded a set of screw caps for RRD twintip kiteboards! 🪁 Designed to snap over the deck-side screws and protect your board from sand and salt. Printed in 95A TPU for a snug fit (PETG works too if you prefer it rigid). Great for keeping your board clean and sharp. Check it out and let me know how it fits your setup! 🤙

With summer approaching, your snowboard or kiteboard deserves a stylish stand on your wall or desk! This straightforward stand is simple to print and use. Kiteboarders can also use special TPU fins to hang the board on the wall.