pestcontrolresumes

Masks

Cat Items

Mimi home decoration

for all the fan of Star Warscan be print on A1 mini&nbsp;Print at 100% infill with a layer height of 0.1mm with a base layer of 0.2mmSwap Instructions: Start with Black At layer #15 (0.6mm) swap to Brown At layer #18 (0.9mm) swap to Green At layer #28 (1.9mm) swap to Grey for the rest.&nbsp;my others hueforge<a target="_blank" href="https://makerworld.com/en/u/2044748376/collections/110344" rel="nofollow noopener">https://makerworld.com/en/u/2044748376/collections/110344</a>&nbsp;my others designs<a target="_blank" href="https://makerworld.com/en/u/2044748376" rel="nofollow noopener">https://makerworld.com/en/u/2044748376</a>&nbsp;&nbsp;

Mandalorian and Grogu hueforge

tiff

ak_211779

<h3>Print instructions</h3>Rafts: NoSupports: YesResolution: 0.2Infill: 15%

Dachshund Low Poly

Ideas

FilliFuu

From the new Bethesda game ‘Starfield’ Credsticks are the universal currency in game. &nbsp;Only requires a tiny amount of glue to stick the fascia onto the case, or if you choose, you can glue to covers together to create a single credstick without the need of the case. &nbsp;The rear snaps together without the need of screws or a filament hinge.&nbsp;I worked hard to create a prop that I hope fans of the game enjoy and can print within half a day.&nbsp;Recommended print settings… &nbsp;-I recommend following the .3mf file and keeping whats set there, however the cover plate would be much better printed using a 0.2mm nozzle, however if using a 0.4mm nozzle - i highly recommend dropping the outer and inner wall line width to between 25-30mm.&nbsp;-If using silk, specifically the gold, as you may know from experience its best to print silk slowly and hot to achieve a high metallic effect. Another thing to add would be that it's better not to add any ironing. Although iron creates a smooth top, it will remove any gloss effect from the silk. I hear about annealing an ironed surface using heat to try restore the gloss, but I haven't been successful with this, perhaps other might.<ul><li>Ironing can be used on the case section for a brilliant smooth surface. </li><li>glue the 4 locators into the case notches and then glue the cover fascias onto the case. Very simple, I use mitre bond often, but you can use whatever sticks well, even heated filament I know some people like to use.</li><li>when clipping the lid onto the base, line the two hinges together and with slight pressure push together while as parallel as possible.</li><li>I have had no strength issues using 2 walls, the hinges and latch have been very strong and everything clicked together beautifully using Sunlu pla for the green. The silk gold was Ziro silk pla. </li><li>I tested the case using just silk, it seems far to fragile using silk, printed with a 220 hotend and at 80mm for the speed, definately require a strong filament for the body section (plate 2)</li></ul>Unfortunately, these credsticks hold no actual value other then being awesome, enjoy.&nbsp;

Starfield CredStick Case / Credstick prop

Props