past goed op Bambi rol. slim ontwerp.

My first multi-hours print. It printed flawlessly in slightly over 9 hours on my A1 mini with AMS. This will be a Christmas gift for my daughter-in-law and I'm very happy with the result.

Good design. we went for a long trip in New Zealand and this was attached to our backpacks. people recognised and loved it.

This was fun to print. I printed in PLA and the result was very good. no supports needed.

Good design. solid solution.

My granddaughter picked these. Easy print. some work afterwards due to sharp edges when removing support. nevertheless she liked them a lot. 5 stars because you made her smile!

Very cute, makes everybody smile. some notes: (1) it is very small (height), so if you have a big gap between door and floor, you need to enlarge it (2) the supports were not easy to remove (PLA Basic) so be very careful not to ruin your print.

very good fit. I like the little knob so they attach very securely.

My granddaughter loved them.

works well. easy print.

easy print. looking forward to using this.

simple and elegant. easy print and very useful

in general very happy. print went well. from a design perspective I would like to see the resting “teeth” to be a bit higher for a better grip of the stand.