Prints and assembles easy, need to purchase new desiccant to see how well it works.

Clips fit a few other brands filament rolls with some twisting/turning since the holes were not circular. Works great for BL rolls

Assembly was a little difficult printed in PLA. Had to reprint a few of the short items as there were adhesion issues within the first few layers. Ended up getting the entire thing assembled and working with bearings except for the TPU inserts. Will have to reprint the tpu holder as it is too tight.

Printed in 2 tone Creality Solyein, looks great, easy assembly and holds the guitar well. Printed the 130mm version for a 120mm acoustic guitar.

Printed in vase mode, seemed too thin but after adding dirt and plant it works great

Base uses a lot more filament but seems to be water tight

Might need speed bumped down a bit or adjusted to silent profile once starting the print. There are a few irregular spots on the bottom of the croc. Supports had to be clipped off as they were connected. It didn't leave a noticeable mark though.