I changed the model to print black then color swap to red. Less waste.

Cute? Okay well it's uselessly tiny for my woodworking needs. Barbie sized. I'll have to scale it way up.

Wider model works perfectly. Thx.

Printed without issue. Holds up most of the time. But I've had some slip outs happen.

The leg pads in the print profile failed to print one side correctly of each pad. I had to open in studio to change orientation to vertical. Joints are tight but I'm sure they will loosen up over time. My kid loves it.

I love mine, it really stands out at work. Assembly was easy.

Fun for a while. For my kid they just started falling off, but for me they clicked in just fine the first time.

Love the design. Now part of my EDC.

Print was smooth, that's nice. But it didn't fit blades as hoped. The basic Stanly blades I have are a bit wider than the box.

Clean print. But it is smaller than the photo. Still can't wait to use this in the shop.

Perfect print.

Printed fine till it got to the last over hangs. Print profile would benefit from supports.

Very nice design. Easy assembly. Have you thought about making a 7 inch version?

Perfect for my work earplugs

Profile for printing from app needs support. Otherwise it does a solid job. I printed in PLA.

Oh that's nice.

A bit rough of a print, the tree supports didn't release without a fight. But it works.

Thanks. Now I can stop my kids from turning off the wifi lights and disconnecting them.

Smooth print. Used teal and gray for my artifact deck.