I’m not sure if it was an orientation issue or my bad for trying to use ironing or similar, but I had a lot of anomalies in a channel down the front, and a few parts that hold the chargers came out looking a bit chewed up. I ended up sanding it down to tidy it up. With that said, it’s a nice model that looks really slick with everything on it. Benefits from rubber feet or adhesives as pulling the phone off the MagSafe puck often drags the stand around.

Great! Seemed massive when I first printed it (only my second print) but once I printed a few other things I’m glad it’s the size it is for all the filament waste. The scraper storage is also super handy.

Great model! I resized it down to 69% (nice) to fit a 15mm crystal flute. Perfect!

The model is good and it’s handy how all the pieces fit together, particularly with the spacer at the back making it a perfect fit for the drawer, but the tiny little clips were honestly really difficult to attach cleanly. This made it impossible to assemble inside the drawer as I needed to apply pressure from both sides to clip it, but then trying to insert the assembled frame into the drawer around the screws was also a challenge.

Super nice clean model, great design, works a charm! I printed the model without screw holes and used gorilla adhesive tape to hang it in a wardrobe.