Packout insert for the Doyle 13inch riveter from Harbor Freight

I made these nozzles to be friction fit to the original nozzle that comes with the Hyper Tough 12v Blower

I made a basic headrest organizer for my Ford F250 work truck. I wanted something that was more elevated to hang my hardhat. I also wanted to be able to make it modular and add other accessories later if I wanted to. This prints in a few pieces. A square shaft slides through the hanger like a pass through key. Then the headrest slides into the pass through key to mount the organizer. I also made a couple of half spheres that sit on the hook as my hard hat was sliding around and holds better.

Starlink mini dash mount. I made this modeled to fit the starlink mini on the dash of Ford F250 Superdutys. I needed something sturdy as I work in the oilfield and drive on some pretty rough ranch roads. Just remove the two screws under the rubber tray on your dash and the mount should screw right in with the factory screws. Made with PETG