I love these. they print well and quickly for how many of them fit on a playw

this works beautiful every time

prints really effectively. I had minor drooping on the overhang with inland pla+ using Bambu basic pla profile so you may want to tune if that’s the same as your scenario

with wood filament it looks a bit off but otherwise prints great. the threaded section at the top is a bit difficult to get aligned perfectly but once you do it’s on there very well

works a charm and prints super quick

prints really well

printed well, but a bit weak, helped us size the metal key we needed

prints really well!

highly recommend petg

prints kinda weird on the holes. probably should be printed vertically with hole down

love it. recommend printing in petg to avoid warping from being left in the car. also careful with magnet alignment finally, doesn’t fit 100 double sleeved perfectly so it’s a bit of a tight fit

prints so well!!

prints okay, little sanding needed on some of the connectors. probably would print better on its main holes

the supports under eh overhang are kinda rough to remove with some of the less robust filaments that have layer adhesion issues

prints really well, it is directional though so keep that in mind

works great, snaps together perfectly

worked great, but the cup is a bit too big to sit perfectly in

worked really well. I was worried about the vertical print orientation but it was good. text wasn’t perfect but it doesn’t need to be.

worked great!