Nori

0.2mm layer, 2 walls, 15% infill

Asterisk Keyboard Steno-Overlay

Doctor Who Gallifreyan Symbol Disk

夏至

量角器（protractor）

Protractor

双色无擦料塔（Two color non wiping tower）

Two color non wiping tower

you saved me a buck — beautifully modeled — 10/10

mischorradas3d

Spool for winding filament samples V1

0.28mm layer, 2 walls, 15% infill

A great use for filament leftovers is printing spools for filament leftovers. Except that these, and the V2, have the filament starting hole at a 90 deg angle compared to typical bambu spools, these are exactly what I could haved wished for

Anirban

Bambu A1 - AMS Hub Support

Version 1 - Full Height

stops my hub from making scary crackeling sounds — Tangle detection also still works, wich i was worried about. Thank you very much!

Jakub

Doorstop

I printed this one because its filleted on every edge, exactly like it should be! I printed it out of PLA so it obviously deforms with time, still works tho. The only thing I'd change is to make the inner fillets match the outer ones

Adamslab

Caliper Wall Mount - Hanger For Calipers

0.12mm layer, 2 walls, 15% infill

l really love the chunky form. I'd just wish all of the edges were filleted, just a millimeter or something, so I don't have to manually deburr

fmod

Parallel Marking Gauge Mk II

Mk II 15 cm - MANUAL change, pause at layer 3 and 11

It's a beauty — i measured .5 mm of shinkage over 150 mm with PLA, wich is totally fine for me. If I print it again, I would try to set the paused so that there are more layers for the outer colour, as the bambu white I used wasn't as opaque as I had hoped

modeled with love — by human
and made with love — by robots

Bambu Lab

Swatch Display Board by Bambu Lab

0.2mm layer, 5 top&bot layer swatch

Schnitzl

Oloid

Supports enabled, 40% infill, fast

Printed it out of the shittiest PLA I own and it still printed just fine, and our cats like it too.

K-Studio.ca

Build Plate Cleaner

Microfiber Holder

SimplisticShapes

Skådis - Caliper-Holder

0.2mm layer, 2 walls, 20% infill

Works great and looks great. Only Issue I had was that the supports of the two upper hooks lost bed adhesion during printing, but it still works fine — problem could just be on my side. 
If I would print it again I would use standart supports as the looks of the back side don't matter anyway

sagat

legs for tabletop SKÅDIS

2x m2 0.2mm layer, 3 walls, 15% infill

Mark

Barber Hair Comb

DorAndy

EDC Container

0.16mm layer, 3 walls, 25% infill

supports were a little hard to remove, but apart from that, it's flawless. Really neat, thank you for the model

panhans

A1 Spool Holder Back Mount Adapter - screwless

Great design, exactly what I was looking for! The print holds very solid, nice press fit. Thak you for sharing! 

I wonder If one could use the PTFE Tube Connector for the mini on the A1 — should be the same connetor, right?

Anyway, model gets a like and a boost from me 😄

*printed in Bambu PLA Basic

ShapeX

A1/A1 mini  Cable  elastic  conduit

PLA，Large-sized，0.2mm layer, 2 walls, 15% infill