I actually used the original print profile (where it's torso is not split). Took a while for an amateur painter like me to finish the paint job.

Awesome design. Will be using it to decorate the office at Halloween.

These are so cute. I am a fan of Simpsons. So far printed the 5 Simpson family members before I paint them. Will print other characters too over time.

Thank you for this print profile. It replaced the other design with Lightning cable slot, as my iPhone 15 has a USB-C connector instead of a Lightning connector.

I printed these with PETG instead of PLA filaments, so I can leave these on the spools while they are being dried inside the filament dryer.

Useful accessory. I printed these to be put in the keychain of each car. Customising the colour as the same as the colour, as well as added the number plate on it.

Very useful. Makes removing a spool from my AMS Lite with printed enclosure much easier.

Simple yet modern and stylish.

Great effort in this design. It is a complicated design, greatly affected by support structure. Too many supports make it hard to remove them. Too few supports make some of the overhang print fail. It's a fine balance.