Nigel

AMS 2 Pro-plus (caffeine injection)

Poop box for the H2 series 

AMS 2 Pro Stacking racks

Magnetic Mood Indicator

Universal AMS desiccant bins

WLED Geode

Bambulab Spool Liner for respooling

Old-skool Mac: 4-letter key-kap kit

MicroSD card tube storage

Desk/table lamp for 40mm E27 fixture

PI Strip Clock

Spool edge label clip

Broom handle spool shelf labels

Broom handle spool shelf

AMS Lite Bambu filament clip

Spool holder (prusament aligned)

A1 Poop Conveyor

Another poop deflector

608 printed bearing

This is a pretty box. However, the screw pylons need beefing up. I'd add 4-6 walls of hole support. While assembling, I broke one of the PI mounts, and plugging in a tricky ESP32 I broke all the case mounts. The notes Say M2 screws are used. I think the holes may actually be M2.5? If you make 2.5mm Diameter Pentagons for the screw holes then you can use M2.3 up to M2.6 without problem. I'd probably also add another 10-20mm for the official Pi5 power supply as it appears to be industrial :)

vintage89

Raspberry Pi 4/5 Home Assistant Case

Raspberry Pi 5 - Bigger version for more space for USB-c 

About 75% of the way through a spool and going great. Was a little tight to get on, partly due to the damage on the cardboard spool in the first place, but all good in the end. Works well, When I get to the end of the spool, that'll be when the retract test will happen :) I have weighted silica holders in there though, so I'm not expecting any issues.

anselor

Polymaker AMS Cardboard Spool Adapter 199mm

PLA 0.2mm layer, 6 walls, 25% infill

adds significant bling :) prints well and fits ok.

maCyo42

AMS Riser V2

Sidepanels Hexagon + Small Sidepanels @0.16mm layer, 2 walls, 10% infill

part 1 had a layer shift... twice, both around 10 hours in... but the second print didn't show it too badly and things went together with a little persuasion.

Part 1- 4 @0.16mm layer, 2 walls, 10% infill

Earn this badge when visit MakerWorld more than 20 days in last 30days UTC time

MakerWorld Guardian