Printed pretty well. Fit is a bit tight and yet it still leaks somewhat. Really have to crank it on there. But I'm pretty happy with it.

I gave these out for Halloween and they were a hit. I don't have picture because I ran out of them.

I love this. Came out almost perfect. The only minor problem are the required supports that leave a bit of a rough surface. The model is strategically placed such that the rough spots are in the back where you probably won't notice them. If it bothers you, some light sanding should take care of it

Came out great. I love that these models are separated into parts so I don't have to waste filament on color swaps.

Prints great. The default model is very tiny so I definitely recommend scaling it up. The one in the middle is the original. Left is scaled up, and right is a painted version.

Printed well for the most part. Supports were somewhat hard to remove.

Printed great. Don't have a pic because the wife already took it :D

does the job. printed with PETG

Very cute model! Family and friends love it and keep asking me to print more for them. These two were printed with Ziro Red and Rose Gold Silk filaments.

Very cute and the person I gave it to loved it. The model could use some work though. The Black and White of the head wastes a lot of filament. The eyes are already separated, why not do the whiskers too? The model also could use some supports or rework because the bottom of the head has very large overhangs that don't print well.

Came out great! Family and friends love the design as well.

Works great!

Blade always falls out. Kind of annoying.

Very cute. Going to print some more of the other animals too

Does the job. Not much else to say.

This has helped a ton. When I first got my X1C certain filaments would always hit the hub in the middle and not feed through. This piece solved that problem.

I do like these and still use them, but they are a pain to take on and off every time filament breaks in the PTFE tubes. You can't get the AMS open with them on.