The fit is almost too good fresh off the printer. With use, the wear will loosen it - hence the magnets - but ATM it's difficult to remove the top (that's good). The inside width is close, too, so there isn't much side/side movement. This fits 100 double-sleeved, or 115 single-sleeved cards. But since I need it for 100 single-sleeved cards, I'll modify it to remove 15-20mm; making it slim enough to fit my card briefcase. I love that it has a removable holder for the Commander, providing additional card protection. This print offers two frame options: 1) a covered back, and 2) both sides open to allow you to use two Commanders. Two disadvantage of #2: 1) it exposes the card to the outside making, it susceptible to damage. 2) your opponent(s) may see what deck/Commander that you're about to play. I prefer the single-sided frame, and if I have more Commanders then I just drop them in with the rest of the deck using sleeves in a design that I use exclusively for my Commanders.

Great color and design for the panels, and everything for together very snuggly. However, the hole was too small to pass through a USB cable, and there were places on the panels that had light leakage. The first layer needs more flow, and a second layer is needed just in case.