truly a fantastic print. thank you for making a no AMS version that is efficient with filament. I enjoyed putting it together and think it is now the cutest Pokemon I have printed yet! I already have another I’m printing now to add to my eeveelution collection. thank you!!

lovely design, no issues!

lovely design! I messed up the magnet directions so it doesn’t work properly but that’s my fault entirely. still fun to play with even though it doesn’t align properly.

great design!

the pieces in the rear, especially around the trunk don’t stay together for me without glue. used PLA Matte.

great print!

lovely print!

Incredible little diorama! thank you so much for posting this for us to print. I had some adhesion issues with some small pieces and added a brim to some of the furniture, and layer smoothing issues on the signs (especially the one on clock side and the 3 little ones above the vending machines) but otherwise a truly lovely piece.

great stand! works well with the bumper too.

the feet came off when removing the supports but after a little super glue, they’re as good as new. absolutely adorable but omg the purge was a lot!

great quality! bigger than I expected but it feels really solid and durable.

very good print!

fantastic little container!

Printed in PLA and the corners/edges were really rough. I tried to shave them down but it’s still bumpy on the edges. overall still a good print so long as you don’t look too closely at those areas.

obsessed with this print!! my new favourite ever 3D print project so far.

solid design and works great!

great little frog. but massive print tower

fantastic little strawberry. printed with matte PLA and came out pretty well.