mitus121

Sevro

OverviewAn ethereal and light statue that shows love in artish style.&nbsp;I found that picture on internet as a tattoo on somebody arm and I had to bring it to the world of 3d printing. I recreated and changed it a bit so that it could be printed and presented properly. I don&#39;t know who is original author of this drawing.&nbsp;InstructionPrint and put in bottom base to achieve vertical pose, no glue is needed.To print it, there is need good adhesion to bed.Upper end of sculpture is bond with initial printer starter extrusion. It prevent roll up this section of model. Cut it after print.&nbsp;Update:17.12.23 version 2I made thicker version 2 mm so statuette is more rigid. Previous one 1 mm was too weak and flexible.19.12.23 version 3I changed a little design so it is yet more rigid and does not bend over time.09.01.23 version 4I added alternative larger base to second plate, because some users in comments section said that default base is too weak.

do zrobienia