Great little project. I took the middle face and enlarged it to make it about 250 mm tall...cut some extra off the back,...added a switch, some led lights run off batteries, and a tombstone case and created a rather large great tombstone for Halloween. I was going to post it but I am new at this and the final design is far from optimized.

Loved these posts for Halloween. Great size and printed well. The signs however i.e. 'Do Not Enter' did not fit well into the sign holders...just a smidge too large. Unfortunately, I did not see the problem until after they were printed but a slight adjustment and a reprint (1mm or so smaller in both directions and they fit)

My wife is a big Halloween fan and loved this print

Perfect. Shrunk it down and used it on a sign for a young boy's bedroom. He was impressed.

Perfect. We used it for a 'Puppy Treats' sign for Halloween

Perfect for my needs

No issues. Printed well.

Well done. Printed perfectly. Earned me some wife points on Valentine's day.

Well done. We only needed the mummy and not the sarcophagus. Printed perfectly with some re-sizing for our needs.

Printed perfectly. Perhaps the new softer TPU might help allow a little better compression and make boxes a little easier to close.

These printed perfectly. Hole part where bag slides in was a little difficult to remove.

Printed perfectly on PIS. My wife wanted them for a Halloween Decoration she was crafting.

Printed well. Part of 2025 Halloween decorations. Thank You

Just needed the fries for something else I was printing. Saved me some design time. Thank You