Printed and finished great! Pieces have a nice weight and size to them. Thanks!

This is really well done! Awesome work! It printed great with your recommended settings and the PLA support trick for PETG worked well. I made a couple tweaks to the piece which holds the basket because most of my baskets would not fit. I enlarged the center hole a couple mm and can now fit all my baskets including some ridged ones. I also found the fit between the two pieces to be too tight, so I cut just a bit off the outside of each of the connecting pieces and it works great now. Only made one cup so far, and I found that I’ll have to grind a little coarser than with the OXO Rapid Brewer to be able to press fast enough for soup. Still a great cup though. 20g of light roast ground at 300 microns, 200g water.

Perfect fit!

Turned out great with a mix of marble and silk PLA. Thanks!

Printed great with TPU 95a. I went for the short .8mm version and it seems durable and generates plenty of air. Still waiting on the Zerno to show up for a test fit.

Great print and assembly was fairly straightforward. I did break the steering wheel column trying to put that together and used some glue for the extra engines on the trunk. Overall, a very fun print!

Perfect print. Turned out great, and I can’t wait to put a hot dog on it.

Great print! I scaled it up to 110% to fit some Crayola markers and it worked out perfectly. Thanks!

I have printed a few of these now and they all print and work beautifully. I am going to print the 180mm remix next because my daughter is demanding a bigger one. I would love a 250mm remix as well as straight scaling does not seem to work well. Thanks!

Great shield for a kid. Printed great and really adds some fun to our sword fights. Thanks!

Printed great in black PETG. It was a tad loose maybe from some PETG shrinkage but not an issue at all once the clips were put in place. Huge improvement to the setup and visibility.

Great print and perfect use for my double color silk PLA. My favorite fidget toy so far.

Great print! Perfect fit. I really enjoy how this tidied up the counter. Thanks!

Printed great in PETG. Thanks!

The larger ramp is not super smooth for me so sometimes filament poops get stuck in the first chute. Maybe my fault for printing it in black silk, but the color matches the case really well. Overall, love the project and how well developed it is. The 6x2mm magnets are plenty strong, too.

Print quality was great with black PETG. The left cover snapped in perfectly. No snap on the right side, so it just lays on top which is fine.

Printed great. Not sure if it was supposed to have supports but they came out easy regardless. The purge line removal tool is already starting to lose its edge, so I’ll probably be printing the purge line only removal tool in the future.