maker_cat

0.2mm layer, 2 walls, 5% infill

Cat Sculpture

0.2mm layer, 2 walls, 5% infill, fuzzy skin

0.2mm layer, 2 walls, 5% infill, NO fuzzy skin

Modern Egg-Shaped Tealight Holder

0.2mm layer, 2 walls, 15% infill

Aqara Sensor Holder (cable tie Version)

Aqara Sensor Holder

0.16mm layer, 3 walls, 15% infill

Coarse Comb

60mm Tower - 0.2mm layer, 2 walls, 10% infill

50mm Tower - 0.2mm layer, 2 walls, 10% infill

70mm Tower - 0.2mm layer, 2 walls, 10% infill

ALL Towers - 0.2mm layer, 2 walls, 10% infill

Fidget Spinner Ring Tower

Fidget Spinner Donut Circle

0.2mm layer with different walls/infills/densities

Infill Tealight Holder - octagon

Infill Tealight Holder - hexagon

Infill Tealight Holder - square

0.16mm layer, 2 walls, 15% infill

Simple tray / bowl

Custom Box Organizer

Small Dragan Organizer

0.12mm layer, 2 walls, 15% infill

traviz

Stevenson screen for Sonoff / Xiaomi Aqara sensors

Simple and good printing. 
I had to make the drill holes in the top plate smaller so that the screw would fit.
I also designed a simple holder for the sensor.

DatumCAD

Radius Gauge (1-10mm) External

0.24mm, 2 Walls, Grey/Green

ralf.hoerhager

Sanding Wedge V2

Sanding Block Set

good simple print. works wonderfully. the screw with the thread also works easily. very nice and above all useful!

martonlengyel.design

Print-in-place box // multiple size // square

super print, beautiful box. print-in-place of the hinges worked very well, even though I scaled the box smaller.
support was also spot on and i only had to do a little rework on the closure. i suspect this was only necessary because of the scaling.

suit1337

Bambu Reusable Micro Spool (light, 100 g)

[PLA] 0.2mm layer, 3 walls, 25% infill

super print, worked great! perfect for filament remnants.

maxar

Extreme Tollerance Test

[PLA]realistic ;-) 0.2mm layer, 2 walls, 15% infill

ahedderly

Portable Pentagonal Hangboard - Grip & Strength Training Tool

PETG, 0.2mm layer, 6 walls, 50% infill

All in all, a beautiful model.
I have printed one in PLA so far and this one can already hold my entire body weight.

The print had minimal warping at one corner, but that's not bad. It was worse to remove the whole brim. 
The supports were very good for the lettering, but not for the 10MM cutout. The inside of the 10MM cutout doesn't look so nice.