awesome detail. wonderful print. Will for terrific with the altar and guardian statues!! be sure to check the supports. “auto” didn’t do well for me. a couple minutes double checking did wonders. I used 0.3 top and bottom and they came off like a dream.

came out great!! one thing to note - it’s small at 100%. this isn’t a negative, just double check what you are using this for and scale as needed. my pics are at 175%. in one pic I have a standard average human mini for scale. at 175% it’s a fine shrine size. 200+ would be needed for “epic shrine”. great print. thanks for sharing.

awesome set! the end cap beads were impossible to get the plugs into so I left them off. also the holes were too small for my needle to get through. but a little light drilling and we were golden. I also used fishing line instead of thread for extra durability!

printed great my first set. 2nd set keeps failing - going to go back to setting. still recommend highly!

came out great! 0 issues. thanks for sharing

came out great! printed at 100% will likely do a couple st 150%

terrific design. came out perfect. I sliced off about 7-10mm of the plain stone backing to save some time and filament. looking at the model I could have been even a little more aggressive but I’m not unhappy with it at all! thanks forbsharing!

updated with complete tower this has to be one of my favorite models to date. amazing quality super easy print. used my first boost on it! can NOT wait to print the rest. thank you so much for sharing. one thing for folks to note, the two gargoyles - the lower tips of their wings behind the pillars both spaghetti’d on my. guess I didn’t hav enough supports on them. everything else was flawless. printed with too/bottom z distance at .3 so support removal was a breeze. my pics are at a .2 layer height. I feel I have more than enough detail and the cost / time trade off seems well worth it.

beautiful! 0 issues. worked great.

came out great 0 issues. had some trouble lining it up, other chutes I’ve printed have guide fins in front.

at first I tried a few of my tiles and they fit but tilted (see pic). but then I realized these are made for the fully open underside not the ones with multiple holes. sorry for my confusion. great model for what it is aimed at!

this thing is amazing. slightly upsized since I’m using a H2C. can’t wait to paint it.

printed perfectly on a P1S. no supports. did 2 sets of them. thanks so much!

easy print. came out great. thanks!

gorgeous. having some issues with supports under the belly trying to get them off without too much scaring. but looks amazing in person.

beautiful. came out great. thanks!

came out great! I’m unable to pop the end caps into the half dome pieces so just going to make a good knot at the end! oh! the end pieces hole was too small for my needle to fit through. simple little hand file and problem solved!

great model. as you can see a corner lifted on me but not it just looks like a crack. oh well! thanks for the model

epic. only small issue I had was the bottom of the tail. assuming my supports were wrong.

came out great no issues. one of your orcs for scale :)