awesome thank you!

came out very nice!

haven’t used them yet but they feel sturdy. nice quick print as well. printed with the only petg I had on hand.

Fun!

great print just like the gun. The two dowels for each gives it a nice strength. I obviously wouldn’t swing with real force, but a it’s held on for a few swishes. I will say the way the guard is with the supports under did mean extra work to refinish that surface. though it wasn’t too bad.

I really enjoyed printing this and the sword. both are great designs.

I liked this print. it’s a bit more wobbly than I would like. The circular rings nearly failed due to no support on the outer edges but thankfully it caught back on. however that spot is weaker. overall good print with a few small tweaks.

a little smaller than expected but that was on me for not checking measurements and title, I saw the design and liked it lol. still holds the knife just fine.

works great, pretty fun!

I like the print. gonna paint or stain it. I did notice that the bottom of the mouth piece has some issues. likely needed to paint supports there.

love it! looks great. hole was a little small for my sticks but still works.

printed with translucent blue petg.

easy print very cute!

this printed well. all the lines didn’t quite fill in the logo on the lid but still great print. fits 5x2 magnets just fine. 6x3 wouldn’t fit.