the first time I printed this, it was a little snug on the filament. So I have re-printed it at 102% size and it seems to work just dandy. Thanks!

does the job nicely. thanks

I will give this one high ratings, but can’t suggest a modification. The arms are much wider than the album. So in order to hold the album tight lay in place. I had to put a spacer between the back of the album and the wall otherwise a little bit of breeze or something knocking it will cause it to want to stand up to straight and fall over

Greatly disappointing that the factory part failed after so few prints. Greatly satisfying that I could print my own replacement part! Thanks for this,

This is pretty clever.

Had to fiddle with the tolerances a little (exact o knife) to get it to open and close completely but it works great! Nicely done. UPDATE: I made a custom Gridfinity box for this case. https://makerworld.com/en/models/2582087-custom-gridfinity-box-for-bambu-lab-x1-tool-box#profileId-2847905 The challenge is that the box is slightly too big for a Standard Gridfinity size so you have to use the next size bigger box. I added some custom spacers and now it stays pretty snug "side to side". It is still to slack "up and down" but it was close enough for me. Feel free to alter it for a better fit. I just used "spacers" instead of a total cut-out in order to save filament and cut down on print time.

This little guy is great! Prints well. Results are smooth. Have tried with Glow filament as well as plain white (prefer white). The string requires a little clean up to put together but no big deal. All in all a fun print. Took one to a Halloween party and gave it to the host who LOVED him!