Fits perfectly. Only part to improve would be a better sliding rail/closing mechanism for the decissant tray.

Fits perfect!

Simple and useful.

A bigger cutout for charging cables would be nice because 3rd party cables have bigger plugs. But Ican imagine that there are too many to cover all. I pull out my iphone when charging. Forcing the plug in puts too much pressure on the cover and it bends.

Works fine!

Had other clips first that needs to be hooked under the filament and the end put through a hole. That lead to two times failures in AMS because of tangled filament with the next prints. This version is of small footprint and works perfect for me.

Very beautyful model, works without any problems.

Still printing on the last part, but for now I am absolutely satisfied. Only two issues I had was part 5 bending away from the buildplate on the side that points to part 6 everytime using support PLA for supports. Gave up after two failed prints at different speeds and used the default settings for support. Needs some sanding now to be nice but that will be ok. Next issue I had was with part 1 and the left side of the middle bar. I put them together for a fitting test but it was quite tight. When trying to remove the middle part the connection of part 1 simply broke off. Seems that that region could need a little bit more material, especially where the height change for inserting the middle part is. When finished I will show some pictures.

Was a gift for a friend of my wife. He was satisfied. Printed in PLA basic (blue) for an iPhone 12 mini