Search models, users, collections, and posts
Bio
Been printing for about 3 years. Very much an amateur at designing models but eagerly learning. I print mostly logo/pop culture items, diorama items, and household items.
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Pioneer Maker
Print successful 174 different models and 1,815 hours
Can anyone give me some insight on an issue I’m having? I bought an aftermarket smooth plate to experiment around with a spool of TPU. I ran a test with a small PLA print and it worked with no issues. I switched back to my textured plate and the z offset seems off now (too high). Ran the same print again on the textured plate and it just pushed the filament around into a blob.
No settings have been changed other than the plate selection. Running a full calibration right now. Any suggestions are appreciated!
Share
0
0
0
No more data