I finally finished the build. It looks good and my wife is happy!

First thing i printed when i got my AMS2 Pro. I printed them using PCTG and they came out perfect.

Printed just fine. Puzzle is a little too easy and with multiple solutions. maybe ill look for something harder next time.

Printed 4 of the thicker version. Worked well, but seems like Sunlu changed the PLA+ 2.0 spools to be bambu identical so im still using them but they are seeing less use.

My very first print

Printed for nephew with couple other minecraft themed prints. he loves them

Printed this for my nephew. He LOVES it

Ive printed over 20 of the smallest boxes. It goes well in ziploc bags for snacks, rice, cereals and everything that needs some sort of humidity control. Makes the cereal and snacks super crispy

Removing support for the white part was extremely hard (I have multiple cuts on my fingers) so be careful guys!

I printed them on A1 with Sunlu PLA+ 2.0. I printed the small pins but even then, the pins are too darn hard to push it inand I had to use plastic snippers to snip some plastic off the pins. For 97% pins, i had to snip the outside a little, but changing the scaling to 94% makes the round pins too narrow and had to snip a little of the insides. Bucket was hard to assemble (my fault, slightly wet filament) and it is impossible to slide it out of the box. Most likely will need to sand or lube the rail. still 5/5 and will print again.