jclimb94

Jakokln

USB A holder for a 1X1 Gridfinity. Holds up to 8 USB drives. Spacing is wide enough to hold most flash drives or adapters. Designed this to replace my old non-gridfinity holder that I have used for many years. &nbsp;Slight taper in the pockets, to help lock in the USB devices when inserted. Slightly oversized for a snug fit, without being too tight. &nbsp;Print with the gridfinity base down. I normally use supports for the magnet holes. Any layer height should work, I use 0.2mm. &nbsp;Need USB C instead? Check this out: <a target="_blank" href="https://makerworld.com/en/models/75455#profileId-79961" rel="nofollow noopener">https://makerworld.com/en/models/75455#profileId-79961</a>Need USB A & USB C? Check this out: <a target="_blank" href="https://makerworld.com/en/models/75457#profileId-79963" rel="nofollow noopener">https://makerworld.com/en/models/75457#profileId-79963</a>

utilities