MTB disc brake pads often come in cardboard boxes that are bulky, impractical, and offer little protection. To solve this, I designed and 3D-printed a custom TPU case with TPU-95A a flexible, impact-resistant material.

Hi there Creality SPARKX i7 Color Combo is delivered with one five-port cable clip to secure PTFE tubes and tool head cable together. When using the external spool, you have to remove the clip from the CFS Lite PTFE tubes to install it on the PTFE tube coming from the spool holder. So I designed and printed a two-port clip that secure PTFE tube from spool holder Please let me know if you like it and feel free to send me comments and possible improvements you may think about. Cheers

Hi there, I wanted to store desiccant beads into my brand new Creality CFS Lite to keep filament dry. I design a simple box with a sliding door that are placed inside space located behind each spool slot used also by the desiccant bags. Please let me know if you like it and feel free to send me comments and possible improvements you may think about. Cheers

Hi there, If you are like me where your Creality SPARKX i7 is placed along a wall without much space, you'll need for sure a narrow bucket to recover filament purge waste. Please let me know if you like it and feel free to send me comments and possible improvements you may think about. Cheers

Hi there A friend of mine, playing Backgammon, ask me for a special doubling cube or dice to increase strategic challenge of the game. So here it is Let me know if you like it and feel free to send me your comments Cheers

Hi there After designing standard clips for my ski and trekking poles https://makerworld.com/en/models/2325692-ski-or-trekking-pole-clip-parametric#profileId-2540529 I designed a foldable model you can leave on your pole to don't lose it. Any feedback or comment will be welcome Enjoy JC

Hi there I just published here a ski or trekking pole clip that can be sized at your need and adapted to your poles, using Fusion parameters Any feedback or comment will be welcome Enjoy JC

I wanted to have similar hanger than the Bambu scrapper one for my cutting pliers. I design the hanger with same external size and just extrude inside with taper angle. Model include Bambu Lab logo and hollow areas on the back for the magnet or double-sided tape. Same as the original model Let me know if you like it and feel free to send me your comments Cheers JC

Hi there, Winter arriving, I had to install the winter wheels of my vehicle. But the Stanley jack I've got was delivered with a flat pad that didn't fit my new Hyundai Kona EV. I designed my owned adapted to the lift point profile of my Kona EV. Note that It should fit to other car models. Just check size profile with included drawing. Let me know if you like it or if you have comments(Edited)

For french audience, j'ai publié un modèle de remplacement de la serrure d'un compteur de rue EDF. Il doit aussi se monter sur un coffret GDF Au cas où l'autre modèle est là https://makerworld.com/en/models/1955309-lock-for-gdf-meter-door#profileId-2101407 Enjoy