jbwaterman84

Ibot_11

This is based on the current version of the CW2 (07.01.2022)A remix of the SB filament runout sensor. I started from scratch and moved the trigger point as far away as possible to give klipper time to react to the runout.Also compatible with a SB2040 board. Bend the pins of the microswitch and apply some electrical tape on top to prevent any shortages. To mount the switch just use your typical 2x10mm self tapping screws.You'll need a 5mm steel ball for this mod.&nbsp;V1.1: Added build-in bridging support

Clockwork 2 Filament Runout Sensor

Voron

Poolshark314

I created a drawer to attach to Honeycomb Storage Walls (HSW). I needed mine to hold the Bambu tools, but it could be used on any standard HSW.&nbsp;Dimensions of the drawer are: 130mm x 63mm x 49mm tall.Cabinet mounts to 2 pegs and spans 5 hex slots (3 within the same row, skipping the middle one)&nbsp;Feel free to reach out for any modifications or custom sizes!

Honeycomb Storage Wall Drawer

Veiko1

From original post: Phone holder with an angle adjustment knob allowing for fine control of tilt. Prints in place, no supports.&nbsp;Phone holder allows for fine control of tilt. Probably overkill for some uses, but think this might be useful for video chat or work conferences where you want to get the camera angle just right. Link to adjustment demo GIF: <a target="_blank" href="https://drive.google.com/file/d/1McKVSAtGteZpH0tnaasFR7kEc2QWJiKA/view?usp=sharing" rel="nofollow noopener">https://drive.google.com/file/d/1McKVSAtGteZpH0tnaasFR7kEc2QWJiKA/view?usp=sharing</a>&nbsp;A little PTFE lube helps it run smoother

Voron

HSW

Other