Turned out great! I haven't gotten a chance to test it out yet, but I'm sure it'll be fine. My only issue is that the chute that attaches to the back of the printer has a slight gap between the chute and the back of the machine. I don't think it'll affect the operation. I believe it's because one part of the leg of the chute is rubbing up against the back of the printer, which may be the reason the chute is not sitting flush. I also ran out of the green SunLu filament and had to finish off with Bambu Lab green filament. So, there is a slight color difference, but it is what it is!! Overall, very happy!

I printed my skadis pegboard off a print from Maker World and had to decrease the size of the key in order to make it fit more securely. I also wish the piece was a little bit longer to hold more of the spool. I couldn't figure out a way to do it without increasing the overall size of the print.

Great storage solutions for multiple accessories! Thank you!

Turned out great and works as it should! Easy Access and storage!

Convenient storage and my deburring tool fit perfectly! Easy access!

Turned out great and makes it easy to access my Gerber!

I was able to modify it to fit my needs and it turned out great!

Took forever to print because of how large an area I was covering. Well worth it! I had some doubts about the stability of the pieces when joined together (due to the vibrations from the 3D Printer) and probably should have superglued the connections. Overall, I think it turned out great! Now I have to start printing some stuff to hang on it!!!

Makes hanging a picture much easier but the picture wire can get stuck in the gove of the piece, depending on the weight of the picture. Just makes it a little difficult to hold onto the jig, whill trying to remove the picture frame.

Came put great and can't wait to start using it!

The bird feeder turned out great! I did have an issue with the print quality of the extension. I was using Sunlu PETG, which I had dried for 6 hours prior to using it. the top part, where you screw the roof into, was stringy and the surfaces weren't completely filled in. you can see what I'm talking about in the second photo. you can't see the stringy filament in the photo because I had already pulled it off at that point. I tried printing it twice and the second time, the exact same thing happened. I used the exact same filament for the bottom half of the feeder and didn't run into the same issues. it just makes screwing the roof on and off a little difficult. other than that it turned out fantastic!

The print went well and the person I gave it to was very happy with it!

Did what it was supposed to do.

Clean print and will look great once I get the LED lights installed! Just one question...does the white insert also get glued to the front piece, before the back is installed? Mine was loose when I dry-fitted it into the front piece.

Great design but when you hold the two pieces back to back, the hat isn't the same height and it isn't really sturdy enough to hold back books, unless you attach the supports. I'm also not quite sure who the character is beside Alice.

Looks great! It was a little difficult removing some of the supports.

I love that I gained so much workspace by moving the mount on top! This is a must download!!! It's a part of the machine now!!

Turned out perfectly!!!! Printed it again, 150% bigger and added yellow lights. I used the exact same filament. The yellow lights gave it the slightly green tint.

Great way to organize and dispense your trash bags!