ivegottaproblem

cover

IMG_3492.png

IMG_3493.png

IMG_3494.png

IMG_3495.png

IMG_3496.png

IMG_3491.png

IMG_3497.png

Spring Version 2 - 0.5 inch compression

IMG_3540.jpg

IMG_3541.jpg

IMG_3542.jpg

IMG_3543.jpg

IMG_3544.jpg

IMG_3545.jpg

IMG_3546.jpg

IMG_3547.jpg

IMG_3548.jpg

IMG_3549.jpg

IMG_3550.jpg

IMG_3551.jpg

IMG_3552.jpg

Gear System (Gearing up/ down) Version 2

just a table

Ergonomic Microphone Handle

M1 to M8 Length 35-5mm Simple Metric Screw Storage

Spring Version 3 - 1 inch compression

Enclosed Gearing System (Gear up/down) Version 3

Minimalist Scissor Holder

Magnetic Levitation Train Version 2

Magnetic Levitation Train V1

1 Inch 3D Printed Spring (test)

Gearing Down/Up Gear Pair

Really good. Good tooth distance and length. Pretty strong.

LOAM

Butterfly comb!!!

Full Butterfly Comb (with comb) 100% infill for weight

It works pretty well. It does take a good bit of hardware, so if you don't have these things laying around, it will be a little inconvenient for you. It's not a very aesthetically pleasing knife, but you should print it if you want to.  Hope this helps. 

Bolt3DDesign

Butterfly Knife Trainer

0.2mm layer, 4 walls, 80% infill

This works really well and printed quickly. Simple yet effective fidget cube. I've seen this design before, and this one works as well. No complaints, but it's nothing special.

Theo_Gruen

infinity fidget cube

0.2mm layer, 2 walls, 15% infill

This katana printed really well and is extremely satisfying to use. You do need to break it in a little bit. The first couple times you extend it, it will be difficult to retract, but after the first couple uses it will work itself out. Would recommend! Hope this helps.